Aluminum Epoxy Putty Stick

Aluminum Epoxy Putty Stick 1.The ultimate solution for small or emergency repairs 2.Easy-to-use and mistake-proof

Aluminum Epoxy Putty Stick

Quickaluminum Aluminum-Reinforced Epoxy Putty Stick

Product Description:

QuikAluminum is a hand-mixable, fast-setting, non-rusting, aluminumreinforced

epoxy putty that quickly repairs or rebuilds anything

made of aluminum. After mixing, it forms a polymer compound

that can be molded into shapes or used to build up, repair and

patch items made of aluminum. The industrial-strength product

cures tough and hard and bonds tenaciously to metals. Each

handy stick contains pre-measured portions of activator and base

throughout — no measuring or mixing tools are necessary. The

consistency (like modeling clay) eliminates drips and runs, molds

easily, and facilitates adhesion to the substrate. After 60 minutes

the application can be drilled, tapped, machined, filed, ground

and painted. It cures to a light-gray metallic color. Suitable for

interior or exterior use, it is resistant to water, chemicals, and

temperature extremes. It contains no solvents or VOCs. QuikAluminum

is non-flammable and releases no noxious fumes. It won't shrink

or pull away. The unused portion stays fresh for future use when

saved in its original package.

Performance Data:

SHELF LIFE AT 75°F (24°C), minimum 24 months

SHORE D HARDNESS AT FULL CURE (24 hrs) 80

LAP SHEAR TENSILE STRENGTH

On aluminum (1" x 1" x 1/16") 500 lbs (3.5 MPa)

On steel (1" x 1" x 1/16") 600 lbs (4.2 MPa)

COMPRESSIVE STRENGTH 8,000 psi (55 MPa)

DENSITY 13.4 lb/gal, 1.6 gm/cm3

SHRINKAGE <1%

NON-VOLATILE CONTENT 100%

ELECTRICAL RESISTANCE 30,000 megohms

DIELECTRIC STRENGTH 300 volts/mil

UPPER TEMPERATURE LIMITS

Continuous 250°F (121°C)

Intermittent 300°F (149°C)

CHEMICAL RESISTANCE

Resistant to hydrocarbons, ketones, alcohols, esters,

halocarbons, aqueous salt solutions and dilute acids

and bases.

How To Use:

Before applying, roughen and clean the area to be repaired.

Then follow these easy steps.

1. Cut or twist off required amount.

2. Mix by kneading with fingers to a uniform color. If mixing is

difficult, warm QuikAluminum to room temperature or slightly

above.

3. Apply to surface to be repaired within 2 minutes of mixing.

Force into any cracks or holes and strike off excess material,

preferably with a tool moistened with clean water.

When applying to a damp, wet or slowly leaking area, work

the mixed material forcefully into the surface and apply pressure

until adhesion begins to take effect.

For best results: Use damp fingers for easier mixing, application,

and a smooth appearance of the cured compound. Remove

excess material before hardening begins.

Curing: QuikAluminum has a 5- to 7-minute work life. Functional

cure occurs in 60 minutes.

Aluminum Epoxy Putty Stick